На всякий случай скопировал текст. Если я правильно понял это процедура адаптации на месте 8 АКПП
The best way to reset Audi transmission adaptation values is to use an OBD2 scanner designed for Audi / VW vehicles. Below you will find instructions on how to reset Audi transmission using VAG-COM and VCDS software. Make sure there are no fault codes stored in the ECU or transmission module. Under Engine [01] and Transmission [02] go to Basic Settings and reset both Kick Down Alignment and Throttle Body Alignment.
Turn on the ignition but not start the engine. Do not press the gas pedal yet.
Go to [02 - Auto Trans]
[Basic Settings - 04] or [Basic Settings - 01] for 09G Trans
Set Group to "000" or "060"
Select Go and press the gas pedal all the way down. Keep gas pedal pressed for at least 4 seconds. No need to press the gas pedal on 09G.
Hit DONE and release the gas pedal.
Alternative method
Turn on ignition. and load your VCDS software.
Select [01 - Engine]
Go to [Basic Settings - 04]
Set Group to "063" and "060"
Press GO and wait for the ADP. OK to display under Throttle Body Alignment Status.
Go back and release the gas pedal.
|